Easy to connect single or multiple standard Modbus slaves and configure selected Modbus registers. Assure no data loss at any condition because of Our Wiman Proprietary RTOS and inbuilt Intelligent Logger system will take priority tasks.
Modbus Gateway Highlights
- Intelligent Modbus, IO, Data Logger, GPRS Connectivity
- Enable your Alert Messages on Set Range Values as EDGE Compute.
- 1 x RS-485 port for RTU Modbus, 1x TCP port for TCP Modbus, USB for Configuration
- Poll Both RS485 RTU Modbus and TCP Modbus (Multiple IPs)
- Configure and Read Multiple Slave IDs, Selectable Register Address data.
- Parameter Data type, Byte Swapping Conversion and Scaling factor enabled.
- Transparent Modbus or Device Inbuilt Polling – Formatted to (ASCII/HEX/RawHEX)
- Smart Inbuilt Data Logger works during Network and Server Disconnection
- Logger Sends offline data once Network and Server Connected
- Authorized numbers list for command and Configuring.
- Configurable TCP/Http/MQTT/Https Mode, GET/POST Methods
- Configurable CSV/JSON Format for Parameter Packetization
- Remote Configuration through SMS/GPRS/Server IP Commands
- Additional 2 x Digital, 2xAnalog Chanel (0 to 24V), 1 x 4 to 20mA Chanel and 1x Relay Output
- Alerts: Power Failure Restore, Low battery Shutdown, Digital IN Changes, Device Reset.
- OTA (Over The Air) Firmware upgrade, Device Configuration update.
- LED indicators to provide GSM, GPRS, Signal, Modbus Tx/Rx COM Status.
- Configurable Server Connection: Connects on Demand or Always Connected.
- Keep Alive command to maintain socket connection
Application Segments
- Automatic Meter Reading
- Solar Inverter Monitoring and Control
- Generator Monitoring and Control
- Energy Monitoring and Control
- Fault Indicators
- Temperature Alerts, Indicators
- Pump Control, Flow Measurements
- Water Level Monitoring and Control
- Home Automation
- Windmill, SCADA, Data Exchange
- Central Monitoring and Control Systems
- Base Station, ATM Monitoring and Control